1. Fold ribbon as shown, leaving a 2" tall.
Next step will begin at outside point indicated by
arrow.
2. Roll outside point tightly towards fold area (about 3 to
4 complete turns) to form a center "bud" and a tight base
area. This area, indicated by an arrow, will be the base for
the rose.
3. Now you are ready to begin the fold and roll motion:
Holding tail firmly in the left hand, fold ribbon length to
outside at a sharp right angle. Roll base area along folded
edge until it is almost at the fold. As you near the end of
the fold, fold the ribbon to the outside again at a right
angle. Repeat this fold and roll process to form rose
"petals" that will form loosely around the bud and base. A
gentle twist on the rolled tail will softly shape and
tighten the rose.
4. When you have about 2" of ribbon left, then twist the
ends straight down and along the first tail. Secure with
florist wire tightly at the base.
LEAF:
5. Cut a 6": strip of #16 ribbon (1-7/8"). Make a point
along one edge by folding ends diagonally towards center, as
shown. This point will become the tip of the leaf.
6. Place your thumb over the point of folded layers and
twist bottom edges of ends tightly to form a cup or leaf
like shape: spot hot glue if necessary.
DESIGNER TIP:
Make a stem rose: Place a firm wire against the
ribbon tails. Wrap the base tightly with Stem Tape
continuing down the length of the stem. If desired, add in
few silk leaves to create fullness
